This fine art, adult coloring book includes 43 japanese woodblock prints. Coloring these black and white drawings takes you to the other time and place. Enjoy and relax!Woodblock printing in Japan (mokuhanga) is a technique best known for its use in the ukiyo-e artistic genre of single sheets, but it was also used for printing books in the same period. Woodblock printing had been used in China for centuries to print books, long before the advent of movable type, but was widely adopted in Japan during the Edo period (1603-1868). Although similar to woodcut in Western printmaking in some regards, the mokuhanga technique differs in that it uses water-based inks-as opposed to western woodcut, which often uses oil-based inks. The Japanese water-based inks provide a wide range of vivid colors, glazes, and transparency.The technique for printing texts and images was generally similar. The obvious differences were the volume produced when working with texts (many pages for a single work), and the complexity of multiple colors in some images. Images in books were almost always in monochrome (black ink only), and for a time art prints were likewise monochrome or done in only two or three colors.The text or image was first drawn onto thin washi (Japanese paper), then glued face-down onto a plank of close-grained wood, usually a block of smooth cherry. Oil could be used to make the lines of the image more visible. An incision was made along both sides of each line or area. Wood was then chiseled away, based on the drawing outlines. The block was inked using a brush or brushes. A flat hand-held tool called a baren was used to press the paper against the inked woodblock to apply the ink to the paper. The traditional baren is made in three parts, it consists of an inner core made from bamboo leaves twisted into a rope of varying thicknesses, the nodules thus created are what ultimately applies the pressure to the print. This coil is contained in a disk called an "ategawa" made from layers of very thin paper which is glued together and wrapped in a dampened bamboo leaf, the ends of which are then tied to create a handle. Modern printmakers have adapted this tool, and today barens are made of aluminum with ball bearings to apply the pressure are used; as well as less expensive plastic versions. Although the first prints were simply one-color, with additional colors applied by hand, the development of two registration marks carved into the blocks called "kento" were added. The sheet of washi to be printed is placed in the kento, then lowered onto the woodblock. This was especially helpful with the introduction of multiple colors that had to be applied with precision over previous ink layers.(source: Wikipedia)