Since combinatorial chemistry and high throughput screening have become a common technique in the drug discovery phase the number of compounds being considered has increased frequently. These structures are often characterized by high molecular weight, high lipophilicity and low solubility in aqueous and physiological media. Due to the generally poor bioavailability, new in vitro techniques were needed for screening of pharmacokinetic properties. An important parameter for these screening methods is the implementation at an early state of drug discovery phase, to find potential lead structures, before investment costs become significant. The established in vitro methods for the prediction of membrane interaction are not reliable especially for poorly soluble compounds. A new method that is fast and easy to use, requires only small amounts of NCE and which can provide more reliable predictions is needed. In this study, a new screening technique based on surface activity profiling for the prediction of oral drug absorption was evaluated with special emphasis on the predictability of biological membrane interaction of poorly soluble drug compounds. It was demonstrated that drug absorption through a bilayer membrane can be modeled by the orientation of compounds at the air/water interface. Thus amphilicity of a drug is generally related to both oral absorption and blood brain barrier penetration. In turn, amphiphilicity is influenced by the lipophilicity, size and charge distribution of a drug. Surface activity profiling was determined by analysis of surface pressure profiles using the Gibbs adsorption isotherm. The surface activity measurements were carried out using a multichannel tensiometer Delta 8, which was developed by Kibron to be utilized in conjugation high throughput screening in early drug discovery processes. For this study two test sets were analyzed, one for the prediction of gastrointestinal wall interaction and the second for the prediction of the penetration behavior at the blood brain barrier. Both test sets consist of drug compounds with a wide range of absorption properties and consist mainly of compounds with poor water solubility. Since the drugs characteristics varied, they were classified according to water solubility and surface activity and a sample preparation method for each group was established. For the prediction of oral drug absorption, three different methods were established to model the interaction of compound and gastrointestinal wall. For drug compounds with solubility above 1mmol/L the traditional shake-flask method enabled the determination of the amphiphilic properties of drug compounds in pure aqueous media. Compounds with solubility below 1mmol/L tend to not to exhibit any increase in surface activity. Thus surface tension measurements of compounds, which exhibited a limited surface activity due to poor aqueous solubility, were conducted from stock solutions prepared with various organic solvents. Mainly polar organic solvents were used. A mixture of DMSO and DMF resulted in the best combination of the intensive solubility enhancing effect of DMF and the lower intrinsic surface activity of DMSO. The polar solvent ruptured the water clusters, so that highly lipophilic structures had a higher affinity to the solvent and higher concentrations could be obtained. For these compounds higher maximum surface pressure were generated than was possible in pure aqueous media. The surface pressure data were correlated with the fraction absorbed values in vivo However it was found that poor water solubility is not the only limiting step to exhibiting any surface activity. Some compounds were showed no surface activity in either solvent system. Therefore a micelle vehicle method was established using short chain phospholipids to mimic the gastrointestinal wall. It could be concluded from the results, that non surface active drugs